IGNITOR | IDXIGN1930

The Hayward Ignitor (IDXIGN1930) is a hot surface ignitor (HSI) used in Hayward H-Series Ground-Induced Draft Heaters to ignite the gas burner and start heating.

• Heater Call for Heat:
• When the pool thermostat detects the water is below the set temperature, it signals the control board to start the heating process.
• Ignitor Heats Up:
• The control board sends electrical power to the ignitor.
• The ignitor is made of a silicon carbide or silicon nitride material that glows red-hot (around 1200-1800°F) within seconds.
• Gas Valve Opens:
• Once the ignitor reaches the required temperature, the gas valve opens, allowing natural gas or propane to flow into the burner.
• Ignition Occurs:
• The hot ignitor ignites the gas, creating a steady flame in the burner assembly.
• The flame heats the heat exchanger, transferring heat to the pool water.
• Flame Sensor Verification:
• A flame sensor detects the flame to ensure proper ignition.
• If the flame sensor does not detect a flame, the control board shuts off the gas and retries ignition (to prevent gas buildup).
• Heating Continues Until Desired Temperature is Reached:
• The heater continues to run, heating the water, until the pool thermostat reaches the set temperature.
• The ignitor turns off, and the gas valve closes until the next heating cycle.

We want you to have quick and easy access to warranty information for all the brands we carry. Please click on the links below to view each manufacturer’s warranty page:

• Pentair Warranty
  
• A&A (Pentair In-Floor) Warranty
  
• Fluidra Warranty (Zodiac / Jandy / Polaris / Caretaker)
  
• Paramount Warranty
  
• BlueSquare Warranty
  
• Hayward Warranty
  
• All Other Manufacturer Warranties
  

Note: Warranty coverage, registration, and service terms are provided directly by the manufacturer. Please review the details carefully to ensure proper understanding of coverage and claim procedures.